Tips for your bearings! Please read!

[Matty - Himself]

Ok, having trouble keeping your bearings clean, fast and smooth? Well i've got the trick, take your wheels of by unscrewing the nut's at the end of the wheels, then get an aerosol can (any will do) and spray the bearings at the front and at the back, then get some tissue (alot), and clean other the bearing (so there's mud collecting on the tissue), and roll a tissue up (like rollups - fags) and thread it through the middle of the bearing which will clean the middle of your bearing and then sprang once more at both sides and put your washers etc back on and your wheel and before u put the nut back on spin your wheel (smooth and as fast as hell dudes), no joke me and my cusson do it with ours (****You) on ramprage.

Steps

1. Take your wheel nuts of.
2. Remove your wheels and spacers.
3. Give your bearings a spray on each side.
4. Get some tissue and wipe them clean (in and out).
5. Afta you've cleaned them spray one more time on each side.
6. Place back on your board, and spin them u can see the difference.
7. Put the nuts back on also and your off, dudes!

Like new,

- Matty - Himself...

one more thing u might want to spray your truck end (where your wheel fits on abit too!)...;) ;)

[f * CKY ou]

Yeah it makes them proper fast but you have to take your time and do it properly.
I have some Bones Speed cream (and bones redz bearings) so when iv dun that - i put some speed cream on and it makes them even faster!!

[Flip Boy]

nice i might have a try today

[phoenix71]

dude when u said airosole did u mean like deodrant??????
if u did im kool wiv dat coz i still got like 10 cans from christmas!!

[Matty - Himself]

Ye, use it on your bearings dude it works!!!

- Matty - Himself...:p ;)

[BlInDsK8r]

i just use WD-40 on my bearings and it works really good

[airlightning]

sounds good but whats aerosol??:confused:

[f * CKY ou]

Aerosol is deoderant like Lynx or summat

[Matty - Himself]

Body spray inc. Lynx, adidas body spray etc.

It works so if u have any Lynx etc. then now the time they'll come in great use!;)

[skater 4 life]

i don't know how to get my beårings out???:confused: :confused:

[BlInDsK8r]

its kinda hard. you have to get a screw driver and put it in your wheel between the 2 bearings and use the screw driver like a lever to pull the bearing out.

[phoenix71]

or u can take the wheel off and use the truck bolt to get the bearin out

[crkptsnl]

Yo blind dude did u say u use WD-40 on your bearings, cause if so your a f@#$%*&
retard it might make them fast for a little bit but it corrodes the stuff that covers the metal bearing cause metal on its own doesnt spin well, now does it

[smurf88]

Another ****ing thread from 2002.

[Print_Mafia]

to clean mine i pop the caps soak them in mineral spirts then spray them w/ air from and air compressor then soak them in rubbing alcohol them spray them w/ air again. or thts how i clean my rockets it works amazingly

[Ramp]