Transitions

[nocomply27]

Just wanted to see what transitions people are using.... My 1/2 was 5.5 ft trannys and I'm not sure if I'm going to use a launch or 1/4 tranny for the spine....

[BakerStencil]

None.

[fliptrickmaster]

i have a slanted ramp to go up and like f/s flip and then go down

[Super AM]

My halfpipe is 6 ft high and the transitions wack, its like steep as hell is a real fast ride, and the air is crazy, not much good for flip on the wall, unless you have mastered the flip ur doin

[evilcheese00]

i used a piece of 8ft string to draw out my tranny on a 3 ft quatar it hella seep i'm gunna rebuild it

[big_hair_pimpin]

yea, i used a grid, so mines perfect. ish. the top is a lil mellow, but thats cause its just a 5, not a vert

[card1]

The best transitions to use are 8 to 9 foot transitions on a ramp that ranges from 4 to 7 feet high. To make a transition measure out a string to 8 or 9 feet and tie a string to the end of it. Have a friend help you hold the other end as you draw on a sheet of 3/4 inch plywood. If you want to learn even more detailed information about transitions you should check out my 54 page guide at buildaramp.com!

[Ramp]